Voir tous les produits
EASYHEAT
Description
Ruban.
- Maintient l'écoulement de l'eau, jusqu'à -40°F
- Pré-assemblé, prêt à être installé
- Avec témoin lumineux d'alimentation
- Avec thermostat à économie d'énergie
- Avec un thermostat à économie d'énergie qui mesure la température des tuyaux
- Consomme 7 watts par pied de câble
- Peut être installé sur des tuyaux jusqu'à 1-1/2-in de diamètre
- Le câble doit être branché dans une prise de courant protégée contre les fuites à la terre
- Le câble doit être installé droit sur le tuyau
Caractéristiques
Longueur (cm)
548,64
Puissance
126
Garantie
Limitée d'un an
Utilisation
Plomberie
Couper à la longueur
Non
Diamètre des tuyaux compatibles (cm)
0,0
Diamètre des tuyaux compatibles (po)
0
Diamètre des tuyaux compatibles (mm)
0,0
Longueur (pi)
18.0
Matériau
Polyéthylène/fibre de verre
Description de modèle
18 pi no 12-Watt Tuyau Heat Câble
Normes de sécurité
Normes de sécurité UL
Nom de la gamme
AHB
Type
Câble chauffant pour conduite d'eau
Épaisseur du mur (cm)
0,0
Épaisseur du mur (po)
0
Épaisseur du mur (mm)
0,0
Vous pourriez aussi aimer
SCHLUTER SYSTEMS
Thermostat à écran tactile Ditra-Heat, 3,5" x 6", PVC, blanc
Format 3.5"x6"
Détails
N° d'article 42815025
SCHLUTER SYSTEMS
Câble chauffant pour membrane Ditra-Heat, 211,6', 240 V
Format 211.6'-240V
Détails
N° d'article 42815019
SCHLUTER SYSTEMS
Câble chauffant pour membrane Ditra-Heat, 339,4', 240 V
Format 339.4'-240V
Détails
N° d'article 42815022
STELPRO
Câble chauffant pour plancher Stelpro, polymère, 3400 W, 240 V, 888 pi, blanc
Format 888'-3400W-240V
Détails
N° d'article 03915274
SCHLUTER SYSTEMS
Câble chauffant pour membrane Ditra-Heat, 248,2', 240 V
Format 248.2'-240V
Détails
N° d'article 42815020
EASYHEAT
Ensemble antigivrage, gouttière/toit, 20', 5 W, 120 V
Format 20' 5W 120V
Détails
N° d'article 03565048
STELPRO
Câble chauffant pour plancher Stelpro, polymère, 675 W, 240 V, 176,3 pi, blanc
Format 176.3'-675W-240V
Détails
N° d'article 03915263
SCHLUTER SYSTEMS
Câble chauffant pour membrane Ditra-Heat, 124,1', 240 V
Format 124.1'-240V
Détails
N° d'article 42815016
STELPRO
Câble chauffant pour plancher Stelpro, polymère, 2580 W, 240 V, 673,8 pi, blanc
Format 673.8'-2580W-240V
Détails
N° d'article 03915272
Can the heat line be installed inside the water line, NOT on the outside of the water line?
No.
Date de publication: 2018-12-30
I am running two plastic pipes, one hot and one cold water, from inside my home to an out side building with on demand heat only. Can I tape the 2 pipes with the sensor cable together with the heat sensor on one of the pipes? please advise
No they need to be independently heat traced and insulated so the heat trace can regulate the temperature better
Date de publication: 2018-10-19
After I install the heat tape, can I wrap the pipes and tape with pipe foam insulation? What is the recommended kind of pipe insulation, foam or fiberglass? (to avoid the risk of fire)
we found that there was no reason to wrap the pipes after installation of the heating cable,....but the should be no difference if insulation were to be used.....would recommend the foam....
Date de publication: 2022-11-25
what if is not straight
- cable bends / conforms to pipe, ...attach with plastic ties.
Date de publication: 2018-03-16
I been doing a little research into what I can purchase to keep a outdoor 100lb propane tank warm as the cold drop the last few days are causing pressure issues and I wanna know if these would work or if there is something else recommend for that purpose?
I am wanting to run plastic pipe water line from my cottage to my garage above ground. The length is 75 feet. Do i just attach the heat trace to the pipe and let the pipe sit on the ground? Or does it have to be covered?
Package indicates the item should only be used on water pipes. I wish to use the item in 3 ft and 6 ft long aluminum 3" x 3" down spout extensions sloped on a 20 degree angle below horizontal and fed from a GFI. Can I do so?
can this be used on pvc or pex pipe
Ruban chauffant automatique est évalué
de
5 de
5.
Rated 4 de
5
de
daveshoot par
Freeze Saver
This is still new to me so I may update later. The recent extended freeze in San Diego (I'm at 1700 feet) caused my well pump pressure switch to freeze up. I purchased this 18' heat cable and a 6' cable for an exposed filter assembly. Such products are hard to find in San Diego area, but the Escondido store had quite a few in several different lengths (Plumbing department item).
They were easy to install and have proven very effective- weather has been colder than when it initially froze up, yet I have not had a repeat of the problem.
You'll need a local 110VAC outlet, and suitable high-temp electrical tape or insulation wrap, which are not supplied with the cable. Installation was straightforward and simple. Instructions are generally above average. These appear to be made in Mexico, rather than China, and at least outwardly appear to be of good materials, fit, and finish.
We'll see how the cables perform over coming days and update if necessary.
Date de publication: 2013-01-14
Rated 4 de
5
de
Just_B par
If it works in Canada - it'll work anywhere!
We live in Alberta, Canada and our winters can fall to below -50 degrees Celsius and colder with the windchill.
Hasn't been quite that cold yet this year but our water froze up on Christmas Eve and it turned out that our original Easy Heat tape had been chewed through by some type of critter. We replaced it, and within an hour we had glorious running water again!
I will say that the one issue I have with these is that the indicator light on the cord does not shut off when there is damage to the cord. We assumed the heat tape was fine because the indicator light was still on - don't rely on this! We had to manually feel the pipe under the insulation to find that it was frozen solid.
Date de publication: 2016-12-28
Rated 1 de
5
de
Dr Zog par
Easy Heat = Junk
This was installed by a professional jobber on my main water inlet. It lasted two months and then failed on Christmas Day, causing my water line to freeze solid. On boxing day I bought an identical replacement, which then failed again as soon as I plugged it in. Easy Heat cables have serious quality issues and will fail when you need them most. Real quality cables from Raychem or Thermon cost quite a bit more but will actually last years, not days. Please save yourself endless grief and avoid Easy Heat cables.
Date de publication: 2016-09-14
Rated 4 de
5
de
jayiw par
Whats inside?
Just in case you wanted to know, if you widdle down the soft plastic, you find out that the hot wire goes through a 36TXE01. I just wanted the cord - put my own digital thermostat on it.
Date de publication: 2021-02-21
Rated 4 de
5
de
stonehead par
Product does what it is supposed to do....simple to install.
Date de publication: 2018-02-14
LIENS PRATIQUES
Services aux consommateurs
Circulaire
◊Achat en ligne
Livraison express
Déclaration relative à la vie privée
Conditions d'utilisation
Exclusivités web
Politique de prix
Plan de protection
Retours et remboursements
Livraison des électroménagers
Informations sur les promotions
Aide et FAQ
Contactez-nous
Trouvez un magasin
Retours et commandes
À propos de RONA
FINANCEMENT
