• icon-wishlist
  • icon-cart
Voir tous les produits MINWAX

Fini protecteur à base d'eau Polycrylic, 946 ml, semi-lustré

N° d'article 14495009 N° de modèle 325034444 Format 946ML
Cet article n'est pas offert pour le moment, mais il peut être commandé en visitant le magasin sélectionné.
icon-wishlist

Description

Le fini protecteur Polycrylic de Minwax embellira vos surfaces de bois intérieures avec une couche de finition lustrée et transparente. Il convient parfaitement aux types de bois légers, notamment l'érable, le frêne et le bouleau. Le produit s'applique aisément avec un pinceau en soies synthétiques et il sèche en 24 heures. Cette couche de finition, formulée à base d'eau et à faible odeur, se nettoie aisément avec de l'eau et du savon. Pour plus de durabilité, Minwax recommande deux à trois couches. On peut appliquer une nouvelle couche après deux heures seulement.

Caractéristiques

Composante
Formule à base d'eau
Couleur
Transparent
COV
275
Fini
Semi-lustré
Format
1 pinte (946 ml)
Intérieur/Extérieur
Intérieur
Emballage
1 unité
Superficie
125 pi² (11,6125 m²)
Temps de séchage
24 heures
Type
Couche de finition protectrice
Utilisations
Protège et embellit les surfaces de bois intérieures, y compris les boiseries, le mobilier, les portes et les armoires

Vous pourriez aussi aimer

Fini intérieur à base d'eau, 472 ml, clair, fini satiné icon-wishlist
SAMAN
Fini intérieur à base d'eau, 472 ml, clair, fini satiné
Format 472ML
Détails
N° d'article 7264038
eco
Vernis « Élite » pour planchers icon-wishlist
FLECTO
Vernis « Élite » pour planchers
Format 946ML
Détails
N° d'article 80455021
eco
Vernis « Élite » pour planchers icon-wishlist
FLECTO
Vernis « Élite » pour planchers
Format 946ML
Détails
N° d'article 80455017
Vernis polyuréthane icon-wishlist
MINWAX
Vernis polyuréthane
Format 946ML
Détails
N° d'article 1449072
Fini intérieur à base d'eau Saman, 472 ml, mat, clair icon-wishlist
SAMAN
Fini intérieur à base d'eau Saman, 472 ml, mat, clair
Format 472ML
Détails
N° d'article 7264094
Vernis d'intérieur « Élite » pour bois icon-wishlist
FLECTO
Vernis d'intérieur « Élite » pour bois
Format AEROSOL
Détails
N° d'article 80455023
Fini intérieur à base d'eau, 946 ml, clair, fini satiné icon-wishlist
SAMAN
Fini intérieur à base d'eau, 946 ml, clair, fini satiné
Format 946ML
Détails
N° d'article 72645119
eco
Vernis Varathane, Diamant, 946 ml, clair lustré icon-wishlist
VARATHANE
Vernis Varathane, Diamant, 946 ml, clair lustré
Format 946ML
Détails
N° d'article 80455013
Vernis polyuréthane icon-wishlist
MINWAX
Vernis polyuréthane
Format 946ML
Détails
N° d'article 1449054
Fini intérieur à base d'eau, 472 ml, clair, semi-lustré icon-wishlist
SAMAN
Fini intérieur à base d'eau, 472 ml, clair, semi-lustré
Format 472ML
Détails
N° d'article 7264039
Vernis polyurethane. icon-wishlist
MINWAX
Vernis polyurethane.
Format 326GR
Détails
N° d'article 1449082
Fini intérieur à base d'eau, 946 ml, mat, clair icon-wishlist
SAMAN
Fini intérieur à base d'eau, 946 ml, mat, clair
Format 946ML
Détails
N° d'article 72645118
Chiffon Applicateur icon-wishlist
MINWAX
Chiffon Applicateur
Format 946ML
Détails
N° d'article 1449240
eco
Vernis professionnel icon-wishlist
VARATHANE
Vernis professionnel
Format 236ML
Détails
N° d'article 03305403
Fini intérieur à base d'eau, 946 ml, clair, semi-lustré icon-wishlist
SAMAN
Fini intérieur à base d'eau, 946 ml, clair, semi-lustré
Format 946ML
Détails
N° d'article 72645120
eco
Vernis « Élite » pour planchers icon-wishlist
FLECTO
Vernis « Élite » pour planchers
Format 236ML
Détails
N° d'article 80455012
Vernis polyuréthane icon-wishlist
MINWAX
Vernis polyuréthane
Format 326GR
Détails
N° d'article 1449083
eco
Vernis « Élite » pour planchers icon-wishlist
FLECTO
Vernis « Élite » pour planchers
Format 236ML
Détails
N° d'article 80455016
Vernis polyuréthane icon-wishlist
MINWAX
Vernis polyuréthane
Format 236ML
Détails
N° d'article 1449025
Vernis polyuréthane icon-wishlist
MINWAX
Vernis polyuréthane
Format 236ML
Détails
N° d'article 1449029
Vernis polyuréthane icon-wishlist
DURATHANE
Vernis polyuréthane
Format 946ML
Détails
N° d'article 1449071
Vernis polyuréthane icon-wishlist
MINWAX
Vernis polyuréthane
Format 236ML
Détails
N° d'article 1449028
eco
Vernis professionnel icon-wishlist
VARATHANE
Vernis professionnel
Format 946ML
Détails
N° d'article 03305406
Vernis « Élite » pour planchers icon-wishlist
FLECTO
Vernis « Élite » pour planchers
Format AEROSOL
Détails
N° d'article 80455015
eco
Vernis « Élite » pour planchers icon-wishlist
FLECTO
Vernis « Élite » pour planchers
Format 236ML
Détails
N° d'article 80455020

Is this food safe? Can I use it on an unfinished wood countertop?

Posée par: DIYMum

Is this product food safe. I burn and carve wood cutting boards and wooden kitchen utensils.

Posée par: ShariGlen

Can I use this product on white painted kitchen cabinets?

Posée par: mayah
  • y_2021, m_1, d_16, h_17CST
  • bvseo_bulk, prod_bvqa, vn_bulk_3.0.12
  • cp_1, bvpage1
  • co_hasquestions, tq_3
  • loc_fr_CA, sid_14495009, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_rona
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • LOCAL, getContent, 1ms
  • QUESTIONS, PRODUCT
Fini protecteur à base d'eau Polycrylic, 946 ml, semi-lustré est évalué 4.6 de 5 de 93.
Rated 4 de 5 de par Be very, very careful not to shake. To Start!!! DO NOT SHAKE THIS PRODUCT!!!! If you want a nice smooth surface. Shaking will infuse tiny foam like bubbles that do not break down and will screw up your finish. I didn't but I had a friend do it, I learned from his mistake. LOL! Anyway, the coating lays out okay. Long even strokes with the widest synthetic brush you can will yield the best results. Eye the results from an angle to see dry spots, bubbles and puddles. Product has a propensity to run and drip so you will need to keep an eye on it. It dries to touch fairly quickly. Sanding between coats is highly recommended for that nice smooth finish. [This review was collected as part of a promotion.]
Date de publication: 2018-08-01
Rated 5 de 5 de par Miniwax water based polyurethane I would use again. Easy cleanup, fast drying, no offensive odor. I little expensive but worth it. I used semigloss on the table for the attached picture. It seemed to highlight the wood grain better than the gloss. I used 3 coats. Keeping the brush strokes even and not going back over a freshly painted area is important . I don't know about durability because it has only been a couple of weeks. I hope it lasts.
Date de publication: 2016-09-29
Rated 4 de 5 de par polycrylic semi-gloss base I am renovating a garage iinto a new home and needed some kitchen cabinets at a value! I chose the basic unfinished cabinets and painted them in grey and used the polycrylic to seal them with to keep them safe and looking good from everyday wear and tear. The product was easy to use just brush on (use a good quality brush and NO BRUSH MARKS). Would recommend to a novice in a heart beat easy to use, great results.
Date de publication: 2015-10-31
Rated 4 de 5 de par Easy to use We used this to Refinish/Distress a kitchen table. It worked great. We used a bristle brush to apply rather than a foam brush and it limited bubbling. Table and chairs came out great.
Date de publication: 2015-12-28
Rated 5 de 5 de par Crafter's Dream! I love this product! I have built several sets of corn hole boards, some all paint, some paint and stain, others paint and vinyl decals. No matter what the base, I finish them off with this Polycrylic Semi-Gloss finish and I couldn't be happier. It really makes the color pop. After applying any stain to the plywood and putting this product over the top the grain looks amazing. My biggest surprise came with its application to vinyl. I was worried about finding something to bond the adhesive vinyl to the plywood decks of the corn hole boards with some degree of permanency. Let me tell you, this finish far exceeded my expectations. It bonds the vinyl flawlessly with no color distortion. I had a rush order come in and I didn't have time to wait for my vinyl vendor to produce a decal. With a WHOLE bunch of hesitancy, I printed with graphic on card stock, cut it out and used stencil adhesive to bond it to the board. Then 4 coats of Polycrylic later (which is what all my boards get) you couldn't even tell I had used a paper product instead of vinyl. If you're a beginner, do not fear this product. It is almost fool proof. Give it a light sanding between coats that have thoroughly dried and you'll end up with a smooth a glass finish, without the yellowing of polyurethane. I have been told there is some discoloration with this product after prolonged sun exposure, but for my applications I have no complaints about color distortion. All in all, I HIGHLY recommend this finish for most crafty projects. Obviously, its not going to replace polyurethane for all applications but experiment with it and you'll find its place in your craft table.
Date de publication: 2013-05-10
Rated 5 de 5 de par Don't hesitate to purchase this product!! Loved how easy it is to apply (no bubbles nor clumping)!! Also liked how quickly it dried and that you can tell, when applying it, where you've put it (as it goes on milky and dries clear)! Will purchase this product many more times!
Date de publication: 2016-07-28
Rated 1 de 5 de par If you want it to look like a home project... I bought this product to put a top layer on end tables and a coffee table for our living room that we had painted white using high quality white paint. I even went for top-of-the-line brushes to apply - and yet, it is still very very streaky and spot glossy. Unless you have a professional painting room with sprayers and rollers and a buffer brush, I'd advise just buying white furniture at this point. Maybe the satin versions are better but the semi-gloss is exactly that - semi-glossy in streaky spots. YES - I've even sanded it and retried multiple times... Minwax - feel free to refund me if you're listening.
Date de publication: 2020-06-15
Rated 1 de 5 de par DO NOT USE ON WHITE PAINT!!! I was painting my oak kitchen cabinets white. Used 2 coats of kills odorless oil based primer. put 2 coats of Valspar cabinet paint. Looked awesome. Nice and bright white. Read that I should use Polycrylic for extra protection from wear and tear. waited a week before I put it on. thought there should be no problem since it is colorless and STATES "dries crystal clear" on can. Big mistake! Turned my cabinets yellow. They look like they were in a smokers house for 20 years. Now I will have to sand them down and start over.
Date de publication: 2017-05-09
  • y_2021, m_1, d_16, h_17
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.12
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_93
  • loc_fr_CA, sid_14495009, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_rona
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • LOCAL, getContent, 2ms
  • REVIEWS, PRODUCT