
Description
This stainless steel drop-in sink from Wessan® is sure to impress your guests. Made from quality materials this sink has overall dimensions of 20 7/8" x 20 1/2" (53 cm x 52 cm), bowl dimensions of 16" x 18" (41 cm x 46 cm), and a depth of 7" (18cm). Comes with centre-rear waste, 3 1/2" (9 cm) strainer, brushed satin finish, 18ga. Equipped with an Off-the-bowl clamp system, factory installed SynkSeal™ foam-in-place gasket, sound deadening pads, custom hole drilling available. Includes template and installation hardware.
Product specifications
All-in-one Kit
Yes
Bowl Configuration
Single bowl
Commercial/residential
Residential
Corner Installation
No
Csa Safety Listing
Yes
Drain Included
Yes
Drain Location
Offset
Drainboard Included
No
Etl Safety Listing
No
Faucet Included
No
Color Family
Stainless steel
Finish
Satin
Heat Resistance In Degrees F
600+
Items Required For Assembly
Jigsaw and screwdriver
Manufacturer Color/finish
Stainless Steel
Material
Stainless steel
Minimum Cabinet Size
Less than 30-in
Mounting Hardware Included
Yes
Noise Insulation
Yes
Nsf Safety Listing
No
Number Of Faucet Holes
1
Number Of Sinks
Single sink
Series Name
Wessan
Sink Gauge
18
Sink Mount Type
Drop-in
Trough
No
Ul Safety Listing
No
Warranty
Limited lifetime
Depth Of Bowl 1 (in)
7
Length (in)
20.88
Number Of Basins
1
Width (in)
20.5
You may also like
How many inches width n length inside the bowl.
The interior dimensions of this bowl are 18" left-to-right, 16" front-to-back and 7" deep.
Date published: 2018-12-03
Wessan Stainless Steel Drop-in Sink - 20 7/8-in x 20 1/2-in x 7-in is rated
out of
5 by
1.
Rated 2 out of
5
by
Quattro from
SS Wessen Sink
Was initially happy this was Made in Canada. The mounting brackets are welded to the sink about 3/4" too high when used on standard post formed counter top with "build-up" so drawers / doors open properly. The sink apron had a slight upward bow in both sides which did not disappear when tightened down. The hold down screws are poorly made and the screw will punch through the "cap / flange" on top if tightened too much - as when trying to eliminate the bow. A portion of the sink apron edge was poorly finished. Required a sink with shallow depth, single hole, so did not have a lot of other choices.
Date published: 2018-12-18