Product selection from
EURAMAX
Description
Protect your home from water damage with the Euramax "Traditional" Vinyl Gutter Connector. This easy-to-install gutter joiner securely connects two lengths of trough, allowing water to be safely re-routed off your roof and away from your property. Made from premium vinyl resin, it stands up to snow, ice, salt, wind and heat without rusting, leaking or crushing. The gutter connector features a snap-seal fitting system that makes installation quick, clean and easy u no special tools or sealants required.
Product specifications
Component
Vinyl
Color
White
Packaging
Each
Style
Traditional
Type
Gutter Connector
You may also like
KAYCAN
Kaycan Vinyl Round Gutter Outlet - 2.5-in x 2.5-in - White
Format 2 1/2x2 1/2"
Details
Article #55395445
do you use these with aluminium gutters, if so what holds the pieces together?
Thank you for the inquiry, the width of the top table is 2.5"
Date published: 2019-05-20
"Traditional" Vinyl Gutter Connector is rated
out of
5 by
28.
Rated 3 out of
5
by
Yniz1 from
Does the Job!
[This review was collected as part of a promotion.] The design of this joint is unique, in how it is supposed to connect. Problem is that sometimes the joint leaks, and it can be a challenge connecting the joint to another part of the gutter. The sliding part is not that seamless to move into place. The joint may need water-proof caulking, and you may need to try and connect joint before getting up on ladder. I still like the design of how it works, in spite of the challenges of connecting. I would recommend this product, especially since it’s vinyl. I already had gutters installed, but needed to make section repair where a worker did something that dislodged the joint in a section.
Date published: 2019-09-18
Rated 5 out of
5
by
SB from
Works like a charm
[This review was collected as part of a promotion.] I’ve never done pvc guttering before, but I am sold. These couplings are quick and easy and require no glue or even sealant/silicone. These have a built in rubberized foam bead that seals tight to the inner side of the trough. And the two sides lock together on the inside of the gutter lip so it does not look ugly or bulbous. Great product!
Date published: 2019-08-07
Rated 5 out of
5
by
Cheryl from
goes together easily and seals well
[This review was collected as part of a promotion.] these fittings were easy to install and they seal well. first heavy rain after the gutter was up and no leaks!
Date published: 2019-08-16
Rated 4 out of
5
by
Silver from
New gutters
[This review was collected as part of a promotion.] This couple works very well, tough to get the four pieces together, but once you do it is locked in place.
Date published: 2019-08-25
Rated 1 out of
5
by
Dan from
Very difficult to attach to gutters
[This review was collected as part of a promotion.] This should have easily connected my two vinyl gutters, but it was almost impossible to attach. I tried sliding each gutter piece into the left and right side of this slip joint. I also tried take this apart and reattach it over the top and bottom of my gutters. Neither way worked very well. I connected it as tight as possible and then I had to caulk the inside.
Date published: 2019-09-23
Rated 4 out of
5
by
Namvette68 from
Makes seams neat looking
[This review was collected as part of a promotion.] These hold 2 pieces of gutter together with aesthetic results. A sealer is neede to make them watertight. I will have to seal all the first pieces I installed. They look nice and will work fine.
Date published: 2019-07-14
Rated 4 out of
5
by
Deadeye from
Slip Joint
[This review was collected as part of a promotion.] It took a bit to figure out exactly how to install it but once I figured it out it went on easily.
Date published: 2019-07-08
Rated 4 out of
5
by
Chabra2002 from
Easy assembly
[This review was collected as part of a promotion.] Using the vinyl gutters were so much easier to assemble over the metal gutters. No leaks.
Date published: 2019-08-24
Helpful Links
Customer Services
About RONA
