Product selection from
SFA SANIFLO
Description
Using SFA Saniflo 0.5 HP transfer pump, install a bathroom or powder room virtually anywhere you like. Designed for use with a bathtub, shower, hand basin and Saniflush rear spigot outlet toilet, it pumps up 15 feet vertically and/or up to 150 feet horizontally. Discharge flow rate at 15 feet is 17 gpm. Requires 3/4 inch or 1 inch (maximum) Sch40 piping to discharge waste. Saniflush toilet bowl (#003) and Saniflush toilet tank (#005) sold separately.
- Install a bathroom or powder room virtually anywhere you like
- For use with a bathtub, shower, hand basin and Saniflush rear spigot outlet toilet
- Pumps up 15 feet vertically and/or up to 150 feet horizontally
- Requires 3/4 inch or 1 inch (maximum) Sch40 piping to discharge waste
- Discharge flow rate at 15 feet is 17 gpm
- Saniflush toilet bowl (#003) and Saniflush toilet tank (#005) sold separately
Product specifications
Water Flow(GPM)
18
Warranty
2-year Limited
Volts
115
Amperage
4.5
Application
Residential
Base Warranty Labor(Months)
0
Base Warranty Parts(Months)
24
Battery Voltage
N/A
Cord Length(cm)
91.44
Cord Length(ft)
3
Electronics Warranty Labor(Months)
0
Electronics Warranty Parts(Months)
24
Horsepower (HP)
0.5 HP
Impeller Material
Plastic
Inlet Connection
N/A
Inlet Diameter
2 inch
Material
Plastic
Outlet Connection
Barbed
Outlet Diameter
1 inch
Package Contents
Fully assembled macerator pump with installation kit that includes: discharge elbow with built-in check valve, toilet-to-pump accordion connector, inlet and vent connectors, blanking plugs and assorted stainless steele clamps
Package Quantity
1
Special Warranty Labor(Months)
0
Special Warranty Parts(Months)
24
Sub Type
Transfer pump
Submersible
No
Switch Type
Specialty
Tank Warranty Labor(Months)
0
Tank Warranty Parts(Months)
24
Type
Specialty pumps
You may also like
BURCAM
Burcam 2-in-1 Stainless Steel Jet Pump - 9-ft Power Cord
Format 3/4HPx115V
Details
Article #0668105
BURCAM
Burcam 1/2 HP Jet Pump with Maximum Water Pressure of 65 PSI
Format 1/2HP 115V
Details
Article #0668602
BURCAM
Burcam 1/12 HP Stainless Steel Non-Submersible Utility Pump - 115 V - 60 Hz - 1325 LPH
Format 1/12HP-115V
Details
Article #0668102
BURCAM
Burcam 1/2-HP Blue Cast Iron Jet Pump - 115/230 V, 2406 à 3040 Lph
Format 1/2HPx115V
Details
Article #0668096
BURCAM
Burcam 1/4-HP Thermoplastic Automatic Under Sink Pump System
Format 1/4HP
Details
Article #56595023
BURCAM
Burcam Black Thermoplastic Fountain Utility Pump - 1/3-HP - 115V - 8600 LPH
Format 1/3HP-115V
Details
Article #56595019
NFORCER
nForcer Thermoplastic Sump Pump with Pre-Assembled Back-Up Kit - 1/3 HP
Article #330729195
Hi, Is the SANIFLO SANI3 0.5-HP Plastic Transfer Pump the complete unit. Seat and tank. if not what would the 3 peace cost. Thanks
The Sani3 is only the macerating pump. You would also require a bowl (Round - 083 or Elongated - 087) and tank (005). All of these items can be found on the website. In addition to the above you may require the extension pipe (030) if you wish to install the pump behind your wall.
Date published: 2023-03-07
Can someone tell me the difference between the SanifloPlus and this Saniflo3? They both say they support 3 piece bath so cannot figure what is the difference besides cost.
The main difference is the size of the macerator pump. The Sani3 is more compact and therefore has a smaller tank capacity. A smaller tank capacity means that it will cycle more frequently and would require some additional plumbing work if you are planning to replace the Saniplus with the Sani3. The motor specs are the same.
Date published: 2022-10-24
How long and how wide is the unit
This unit is 16.25" (413 mm) wide by 10-3/8" (263mm) high by 7.25" (180mm) deep.
Date published: 2022-10-24
Can you send me the instruction manual for this item ?
Please contact our technical department for further information at 1-800-363-5874 or service@saniflo.ca to request the manual.
Date published: 2022-07-26
Can this tank be used with a standard toilet mounted above the tank?
No this cannot be used with a standard toilet. If you are looking for a standard toilet application then we recommend using the Sanigrind Pro.
Date published: 2022-07-26
Can the extension pipe from the toilet to the macerator pump be sloped a couple of inches or does it have to be level
Yes it can be sloped slightly down towards the pump
Date published: 2021-01-26
Does this macerating toilet need to be vented. What are the product numbers for the completing toilet bowl and tank and anything else that it would need it to be used.
Yes it needs to be vented
Date published: 2020-03-02
I have an older unit that needs to be replaced. It has 2 inlets (1 each side) 1 for shower and 1 for sink along with toilet connection. Are the old and new units outlets located the same? In other words can I replace one with the other?
You can call saniflo In guelf Ontario directly to ask them. But my opinion is as long as the model numbers match, you shouldn’t have a problem. This is model “sani 3”. Read the side of your unit to find the model number.
Date published: 2021-10-11
SFA Saniflo Sani3 Macerating Pump with 2-in Inlet and 1-in Outlet is rated
out of
5 by
5.
Rated 3 out of
5
by
escherzi from
Sani3 Experience
I had purchased a house on septic and the basement washroom has the Sani3 Toilet system installed as well as a shower and sink that feed into the plastic transfer compartment. Overall experience is that it works. Sometimes it takes more than one flush to clear the bowl and seems a bit heavy on water used per flush. Make sure your venting is done right because we get some bad smells as if the system is back venting. Could just be our system as we did not install it.
Date published: 2016-10-04
Rated 4 out of
5
by
mommsy from
Merry Christmas, Son!
I purchased this pump for my son who installed it himself. He struggled a bit with the installation - he's not a mechanic or plumber, but is well pleased with the pump.
Date published: 2017-01-13
Rated 1 out of
5
by
Tommy's from
Do not buy pump is not sealed properly
Pump gets water in and burns out. Not sealed properly. We have to change pump 26- 30 months after replacing.there 800$ for pump. Going to different company.
Date published: 2022-12-11
Rated 5 out of
5
by
ZZRIDER from
Replaced my 28 year old Saniplus unit with this
In 1994 I installed a Saniplus unit to a American Standard backflush toilet and a sink and shower. After 28 years the pump failed. It wasn't unexpected after so many years of working fine. The Saniflo Sani 3 unit is made by the same original company. I purchased this unit to replace it. It is a 1/2" wider (8.5') and 4" shorter in length (16") and now has 2" DWV connections to adapt to code. The older unit had a vent built in and I had to install a flexible plastic vent pipe and fish through a wall for proper venting of this new unit as the old cheater are not permitted as a warning sheet packed with the produce described. I purchased a 1.5"-2" rubber connector as only one was included in the install kit. It was the only piece I needed to re-install this new one, plus a couple of longer pcs of 1.5"DWV which I hade around. (Only 1 2" to 2" flexible conector is included too which I did not require with the existing 1.5" DWV). This unit was $300 cheaper than the original unit and I hope it lasts at least half as long. The demensions of the new unit are: 16.5"L x 7"W x 9.25" for the main body of the unit with the 1/2" toilet flange at 8" center from the bottom of the unit. It was a quick and easy re-install and I got lucky fishing the 9 foot flexiable vent pipe through a knee wall that hid the shower DWV from the other side of the bathroom.
Date published: 2022-06-12
Helpful Links
Customer Services
About RONA
